Shandong Ultisolar New Energy Co., Ltd

USN-HS21TX Integrated Hall Water Flow Sensor and Solenoid Valve for Dosage Controller

 USN-HS21TX Integrated Hall Water Flow Sensor and Solenoid Valve for Dosage Controller 

USN-HS21TX

 

Application:

Water heater, washing machine, boiler, electromagnetic water heater, water dispenser, water purifier, R.O. machine, U.F. machine, coffee machine, water machine, water machine control, water control machine, beer machine, beauty equipment, shower equipment, electrolytic water machine, energy engineering, heat pump,IC meter, steam equipment, irrigation equipment, water system, campus card self-service sale (sell) water machine, washing machine, automatic washing equipment, water treatment equipment, water dispensing equipment, cooling system, circulation system, intelligent toilet (toilet), bidet, mechanical equipment, heating equipment,  Pharmaceutical (agents) equipment etc.

Calculation Formula: F(Hz)= 11*flow rate(Q)(l/min)
Features:

1.   PA66 material, environmental friendly material, small, flexible and functional.

2.  Intubation design of inlet and outlet pipe, easy connection and operation;

3.  Imported Hall IC from Taiwan,

4.  Flow Range: 1-30L/min;

5.  Working voltage: DC4.5-18V;

6.  Rated voltage: DC5V;

7.  Output voltage(rated: DC 5V); High level 4.5V and above; low level 0.5V and below

8.  Pulse output duty cycle: 50+-10%

9.  Insulation resistance: 100M Ohm and above;

10. Tightness: Seal up all the holes, and inflate with 0.8MPa water, after 1 minute, no leakage and deformation;

11.  -20-60 centigrade;

12.  Max Pressure: 1.7Mpa

13.  Electrical Strength: AC500V 50Hz.

14.  Wire length: regular 32cm, other length can be tailor made against request.

15.  End connection: SM2.54 Plug/ XH2.54 Plug.

16.  Low power consumption model can be tailor made(10μA)

Solenoid Valve:
Always closed
Pressure: 0.1-0.8Mpa
Temperature: 0-80 centigrade.

 Note:

1.  When  magnetic material is close with  the sensor,its characteristics may vary.
2.  In order to avoid particle debris, the sensor must beinstalled after a filter.
3. The flow sensor installation  has to avoid strong vibration and shaking of the  environment, so as not to affect the sensor's measurement accuracy.

Manual:

USN-HS21TX

 

 

Ultisolar Group:  Shop Ultisolar -|-Ultisensor.com -| -Ultisolar.cn中文版

Copyright © 2010 Shandong Ultisolar New Energy Co., Ltd All rights reserved.

鲁ICP备17032917号-5 Powered by Z-blog